Tempering is a low-temperature heating after hardening (150–650 °C, below A1) that reduces the stress and brittleness of quenched martensite and sets the required hardness-to-toughness ratio. It is done routinely after hardening, carburising or carbonitriding.
Tempering, Poland. Arranged at a vetted plant in Poland, to order, with a non-binding enquiry.
We do not carry out tempering ourselves. reliq is your first point of contact — send us an enquiry and we will connect you with a proven plant in Poland, help you choose the technology and handle communication. You then sign the order, contract and warranty directly with the plant.
Tempering is a low-temperature treatment (below A1) that follows hardening. Quenched martensite is very hard but brittle; tempering slightly reduces hardness, increases toughness and removes stress and brittleness from quenching. This adapts the part’s properties to the specific application.
The tempering temperature is chosen by the required hardness and steel grade, usually 150–650 °C. Low tempering (160–300 °C) is used for case-hardened parts and cold-work tool steels; higher temperatures give higher toughness. In high-alloy steels retained austenite transforms around 550 °C, so a second temper usually follows. Temper brittleness occurs in certain temperature ranges and must be avoided.
Tempering practically always follows hardening, carburising, carbonitriding or induction hardening. If only stress relief without affecting hardness is needed, stress-relief annealing is more suitable.
Quenched martensite is hard but brittle. Tempering reduces stress and brittleness and sets the hardness-to-toughness ratio.
Depending on the steel and required hardness, usually 150–650 °C. Lower keeps more hardness, higher gives more toughness.
No. reliq is an agent: we connect you with a proven plant in Poland and help you choose the technology and handle communication.
Send us a non-binding enquiry. We will connect you with a proven plant in Poland and help you choose the technology and parameters.
Send an enquiry →